1 Scope

This part of IEC 60947 specifies requirements for terminal blocks with screw-type or screw-less-type clamping units primarily intended for industrial or similar use and to be fixed to a support to provide electrical and mechanical connection between copper conductors. It applies to terminal blocks intended to connect round copper conductors, with or without special preparation, having a cross-section between 0,2 mm² and 300 mm² (AWG 24/600 kcmil), intended to be used in circuits of a rated voltage not exceeding 1 000 V a.c. up to 1 000 Hz or 1 500 V d.c.

NOTE AWG is the abbreviation of “American Wire Gage” (Gage (US) = Gauge (UK))

kcmil = 1000 cmil;

1 cmil = 1 circular mil = surface of a circle having a diameter of 1 mil

1 mil = 1/1000 inch

This standard may be used as a guide for

1. – terminal blocks requiring the fixing of special devices to the conductors, for example quick connect terminations or wrapped connections, etc.;

2. – terminal blocks providing direct contact to the conductors by means of edges or points penetrating the insulation, for example insulation displacement connections, etc.;

3. – special types of terminal blocks, for example disconnect terminal blocks, etc.

Where applicable in this standard, the term “clamping unit” has been used instead of the term “terminal”. This is taken into account in case of reference to IEC 60947-1.

1 1.1 This standard specifies requirements for terminal blocks with screw-type or screw-less-type clamping units primarily intended for industrial or similar use and to be fixed to a support, in accordance with Annex DVB, National Electrical Code, NFPA 70 (for use in the USA), or CSA C22.1-15 Canadian Electrical Code, Part I (for use in Canada), and NOM-001-SEDE, Electrical Installations (Utility) ([for use in Mexico]).

1 1.2 The wire range for terminal blocks covered by this standard include 0,051 mm² to 1 010 mm² (30 AWG to 2 000 kcmil) copper conductors and 3,31 mm² to 1 010 mm² (12 AWG to 2 000 kcmil) aluminum conductors. See Annex DVA for aluminum requirements.

In Mexico, 3,31 mm² (12 AWG), 5,26 mm² (10 AWG), and 8,37 mm² (8 AWG) aluminum conductors are not allowed.

1 1.3 The voltage range includes up to 1 500 Vac and 1 500 Vdc.

Summary of Topics

This revision of ANSI/UL 60947-7-1 dated April 16, 2021 is being issued to update the title page to reflect the most recent designation as a Reaffirmed American National Standard (ANS). No technical changes have been made.

As noted in the Commitment for Amendments statement located on the back side of the title page, CSA Group, ANCE and UL are committed to updating this harmonized standard jointly. However, the revision pages dated April 16, 2021 will not be jointly issued by UL, CSA, and ANCE as these revision pages only address UL ANSI approval dates.